Cisco 8961 - Page 171

Configuration ReferenceDescriptionFeature
For more information, see the following:
•
Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phone” chapter.
•
Cisco Unified Communications
Manager Administration Guide,
“Setting Headset Sidetone Controls”
section
Allows you to adjust headset levels to one of five
following settings:
•
Off
•
Very Low
•
Low
•
Normal
•
boost
This feature is only for analog
headsets.
Note
Headset Sidetone Controls
No configuration requiredControls the way that softkeys display in full screen
video mode.
Hide Softkeys in Full Screen
Video Mode
For more information, see Cisco Unified
Communications Manager System Guide,
“Cisco Unified IP Phones” chapter.
Provides flexibility with the flexibility to hide the video
window. When the video is displayed, the user sees the
Hide Video softkey; when the video is hidden, the user
sees the Show Video softkey.
The phone supports a new configuration parameter that
enables the administrator to control whether the video
is displayed or hidden. The parameter is Hide Video
By Default, with values Disabled (default) or Enabled.
Hide Video Option
For more information, see the “Cisco
Unified IP Phone Configuration” chapter
in the Cisco Unified Communications
Manager Administration Guide.
Removes the Wireless Setup option from the Network
Setup menu when WiFi is disabled from the Cisco
Unified Communications Manager.
This feature is supported only on the Cisco Unified IP
Phone 9971.
Hide Wi-Fi User Interface
Setting
For more information about configuring
this feature, see “Hold Reversion” chapter
in the Cisco Unified Communications
Manager Features and Services Guide.
Limits the amount of time that a call can be on hold
before it reverts back to the phone that put the call on
hold and alerts the user.
Reverting calls are distinguished from incoming calls
by a single ring (or beep, depending on the new call
indicator setting for the line). This notification repeats
at intervals if the call is not resumed.
A call that triggers Hold Reversion also displays an
animated icon in the call bubble and a brief message on
the status line.
You can configure call focus priority to favor incoming
or reverting calls.
Hold Reversion
No configuration required.Enables phones with a shared line to distinguish
between the local and remote lines that placed a call on
hold.
Hold Status
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
147
Features, Templates, Services, and User Setup
Telephony features available for Cisco Unified IP Phone
REVIEW DRAFT - CISCO CONFIDENTIAL