Procedure
Step 1
Push the screw drivers into the left and right holes in the phone mounting plate approximately 1 in. (2.5 cm).
Step 2
Lift the screwdriver handles up to put a downward pressure on the tabs.
Figure 24: Disengage Tabs
Step 3
Press firmly to disengage the tabs and lift the phone at the same time to release the phone from the wall bracket.
ADA Non-Lockable Wall Mount Kit for 8961 Series and 9900
Series IP Phones with Key Expansion Module
This section describes how to install the non-lockable wall mount kit on a Cisco Unified IP Phone 8961, 9951,
and 9971 when the phone is connected to a Key Expansion Module.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
334
Cisco Unified IP Phone Non-Lockable Wall Mount
ADA Non-Lockable Wall Mount Kit for 8961 Series and 9900 Series IP Phones with Key Expansion Module
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
