Cisco 8961 - Page 360

Components
The following figure shows the components of the ADA Non-Lockable Wall Mount Kit for the Cisco Unified
IP Phone 8961, 9951, and 9971 with a Key Expansion Module.
Figure 27: Components
The package contains the following items:
•
One phone bracket
•
One wall bracket
•
Six #8-18 x 1.25-inch Phillips-head screws with six anchors
•
Three #4-40 x 0.31-inch machine screws
•
One 6-inch Ethernet cable
Before You Begin
You need these tools to install the bracket:
•
#1 and #2 Phillips-head screwdrivers
•
Level
•
Pencil
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not
currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular
telephone jack. For more information about phone installation requirements and warnings, see Cisco Unified
IP Phone Installation, on page 38 and Cisco Unified IP Color Key Expansion Module Setup, on page 71.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
336
Cisco Unified IP Phone Non-Lockable Wall Mount
Components
REVIEW DRAFT - CISCO CONFIDENTIAL