Cisco ASR 1000 Series - Page 264

9-10
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Cisco ASR 1002-F Router Components
Figure 9-9 shows the DC power supply for the Cisco ASR 1002-F Router.
Figure 9-9 DC Power Supply for the Cisco ASR 1002-F Router
Table 9-3 defines the Cisco ASR 1002-F Router DC power supply LEDs on the Cisco ASR 1002-F
Router.
Table 9-3 Cisco ASR 1002-F Router DC Power Supply LEDs
1 Chassis ESD socket 6 Captive installation screw
2 DC power supply slot 0 label 7 DC power supply slot 1 label
3 DC power supply Standby/On (|) switch 8 Ground lead
4 DC power supply LEDs 9 Positive lead
5 Fan 10 Negative lead
280289
OUTPUT INPUT
FAIL
OK OK
FAN
-48V/-60V 16A
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
OUTPUT INPUT
FAIL
OK OK
FAN
-48V/-60V 16A
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
9 810
4 5 63
0
1
7
1
2
LED Label LED Color Description
INPUT OK Power supply activity Green The DC power supply input voltage is greater than
43.5 VDC at turn-on and remains green down to 39 VDC.
Amber The power supply turns off due to low input voltage (falls
below 39VDC) and indicates that there is still a hazard
present (voltage on the terminal block). The LED remains
amber and is active to around 20 V +/-5 V.
Off The input is below 15V
FAN OK Power supply fan status
activity
Green All fans are operational.
Red A fan failure is detected.
OUTPUT FAIL Power supply activity Red The DC output is out of the specified range. When you
turn the power supply on, the red LED illuminates for two
to three seconds to test LED operation before going off.
Off The DC output voltage are within the normal operating
range.