9-17
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Attaching the Chassis Rack-Mount Brackets
To install the front rack-mount brackets on the Cisco ASR 1002-F Router, perform the following steps:
Step 1 Locate the threaded holes on the side of the chassis. Make certain that you hold the front rack-mount
bracket with the ear and holes facing outward and towards the front of the chassis.
Figure 9-13 shows where to attach the front rack-mount brackets to the Cisco ASR 1002-F Router.
Depending on the bracket holes you use, the chassis may protrude in the rack.
Figure 9-13 Attaching the Front Rack-Mount Brackets to the Cisco ASR 1002-F Router
Step 2
Position the front rack-mount bracket top hole with the chassis first top hole behind the side vent holes.
Step 3 Insert and tighten the black screws on one side.
Step 4 Repeat Step 1 through Step 3 on the other side of the chassis. Use the black screws to secure the
rack-mount brackets to the chassis.
Step 5 Install the chassis in a rack. To install the Cisco ASR 1002-F Router in a rack, go to the “Installing the
Cisco ASR 1002-F Router in a Rack” section on page 18.
This completes the steps for attaching the front rack-mount brackets to the Cisco ASR 1002-F Router.
Chassis Rear Rack-Mount Brackets
If you are rack-mounting the chassis using the rear rack-mount brackets, then this type of installation
provides for the chassis being recessed in the rack.
To install the rear rack-mount brackets on the Cisco ASR 1002-F Router, perform the following steps:
Step 1 Locate the threaded ear holes on the rear side of the chassis. Make certain that you hold the rear
rack-mount bracket with the ear and holes facing outward and towards the rear of the chassis.
1 Front rack-mount bracket ear and holes 3 Front rack-mount bracket screws
2 Front rack-mount bracket — —
S
P
A
-
4X
OC
3
-
P
O
S
S
T
A
T
US
0
1
2
3
C
/
A
A
/
L
C
/
A
A
/
L
C
/
A
A
/
L
C
/
A
A
/
L
0
274497
2
1
3
To Next Page
Loading...
