9-18
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Installing the Cisco ASR 1002-F Router in a Rack
Figure 9-14 shows where to attach the rear rack-mount brackets to the Cisco ASR 1002-F Router.
Figure 9-14 Attaching the Rear Rack-Mount Brackets to the Cisco ASR 1002-F Router
Step 2
Position the rear rack-mount bracket top hole with the chassis top hole from the back.
Step 3 Insert and tighten the screws on one side.
Step 4 Repeat Step 1 through Step 3 on the other side of the chassis. Use the remaining screws to secure the
rear rack-mount brackets to the chassis.
This completes the steps for attaching the rear rack-mount brackets to the Cisco ASR 1002-F Router.
Caution Before you mount the Cisco ASR 1002-F Router in a rack, make certain you understand which
rack-mount bracket ear holes to use when positioning the chassis in the rack. As a result of using the
designated ear holes on the rack-mount bracket, the cable-management bracket installation will be made
easier.
Installing the Cisco ASR 1002-F Router in a Rack
After installing the rack-mount brackets on the chassis, you mount the chassis by securing the
rack-mount brackets to two posts or mounting strips in the rack using the screws provided.
Note Because the rack-mount brackets support the weight of the entire chassis, be sure to use all the screws
to fasten the rack-mount brackets to the rack posts.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable.
1 Rear rack-mount bracket ear and holes 3 Rear rack-mount bracket screws
2 Rear rack-mount bracket — —
To Next Page
Loading...
