14-55
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1006 Router Power Supplies
Removing and Replacing the Cisco ASR 1006 Router Power
Supplies
The Cisco ASR 1006 Router contains power supplies that are field replaceable units. This section
contains the following topics:
• Removing and Replacing a AC Power Supply in Cisco ASR 1006 Router, page 14-55
• Removing and Replacing a DC Power Supply in Cisco ASR 1006 Router, page 14-58
Removing and Replacing a AC Power Supply in Cisco ASR 1006 Router
This section provides information about removing and replacing an AC power supply in the Cisco
ASR 1006 Router.
Removing the AC Power Supply from Cisco ASR 1006 Router
Because of the power supply redundancy, there is no need to power off the Cisco ASR 1006 Router
before removing one of the AC power supplies.
The Cisco ASR 1006 Router has two of the same type power supplies in power supply slot 0 and power
supply slot 1.
To remove the Cisco ASR 1006 Router AC power supply that is not operating normally (and then replace
the AC power supply within five minutes), follow this procedure:
Step 1 Slip on the ESD-preventive wrist strap that was included in the accessory kit.
Step 2 Before you turn off a power supply, make certain the chassis is grounded.
Step 3 Turn the power supply Standby switch to the Standby position.
Figure 14-37 shows the power inlet and standby switch for the ASR1006-PWR-DC power supply. On
the ASR1013/06-PWR-DC power supply, the AC power inlet and standby switch are at relatively the
same positions.
To Next Page
Loading...
Need help?
General
