Cisco ASR 1000 Series - Page 492

14-62
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1006 Router Power Supplies
Figure 14-43 shows the DC power supply terminal block for the ASR1013/06-PWR-DC power supply
of the Cisco ASR 1006 Router.
Figure 14-43 Cisco ASR 1006 Router DC Power Supply (ASR1013/06-PWR-DC) Terminal Block and
Plastic Cover
Step 5 Remove the slotted plastic cover from the terminal block (see Figure 14-42).
a. Loosen and remove the single screw on the plastic cover. The plastic cover has slots that help to slide
it out diagonally from the terminal block.
b. Using a nut driver (7/16 size), unsrew the positive kepnut, positive cable, and the flat washer, in that
order.
The terminal block houses two double-hole barrel lugs.
c. Follow Step 4b and remove the negative cable.
1 Negative lead 3 Protective sleeving around the stud and cable
2 Positive lead 4 Ground stud and cable
OUTPUT INPUT FAN
FAIL OK OK
ALARMS
60V
1A MAX
This unit might have more than one power supply connection. All connections must be removed to de-energize the unit.
-48/-60V 40A
253913
1 2
4
3