14-110
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1001 Router Power Supplies
Figure 14-84 shows the DC power supply with lead wires.
Figure 14-84 DC Power Supply with Lead Wires
Step 7
Insert the exposed wire of one of the ground wire into the terminal block plug. Make sure that you cannot
see any wire lead. Only wire with insulation should extend from the terminal block.
Caution Do not overtorque the terminal block plug captive screws. The recommended maximum torque is from
0.5 Nm (4.425 lbf in.) to 0.6 Nm (5.310 lbf in.).
1 Negative (–) lead wire 3 Ground lead wire
2 Positive (+) lead wire — —
207765
1
2
3
To Next Page
Loading...
