14-111
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1001 Router Power Supplies
Step 8 Use a ratcheting torque screwdriver to torque the terminal block plug captive screw (above the installed
wire lead) to from 0.5 Nm (4.425 lbf in. to 0.6 Nm (5.310 lbf in.) as shown in Figure 14-85.
Figure 14-85 Torquing the DC Power Supply Terminal Block Plug Screws
1 Torque is from 0.5 Nm (4.425 lbf in. to 0.6 Nm (5.310 lbf in.)
To Next Page
Loading...
