Cisco ASR 1013 Hardware Installation Guide

Table 62: Cisco ASR 1002-F Router SPA LEDs
MeaningStateColorLED Label
SONET alarm controller
is shut down.
OffOffC/A
Port is enabled by
software and there is a
valid SONET alarm
signal without any alarms.
OnGreen
Port is enabled by
software and there is at
least one alarm.
OnAmber
Interface is shut down.OffOffA/L
Port is enabled by
software and loopback is
off.
OnGreen
Port is enabled by
software and loopback is
on.
OnAmber
SPA power is off.OffOffSTATUS
SPA is ready and
operational.
OnGreen
SPA power is on and
good and the SPA is
being configured.
OnAmber
Cisco Integrated ASR 1002-SIP10-F and SPA for Cisco ASR 1002-F Router
Description
The Cisco ASR 1002-SIP10-F in the Cisco ASR 1002-F Router is integrated into the chassis and you cannot
insert or remove it. The Cisco integrated ASR 1002-SIP10-F provides the physical and electrical termination
for one half-height SPA.
The Cisco integrated ASR 1002-SIP10-F interface supports all Cisco SPA interface processor functions and
services. However, the Cisco integrated ASR 1002-SIP10-F differs in the following areas:
•
Functions as the base board for the Cisco integrated RP
•
Is not a field-replaceable unit (FRU) and does not support online insertion and removal (OIR)
Cisco ASR 1000 Series Router Hardware Installation Guide
282
Cisco ASR 1002-F Router Overview and Installation
Cisco Integrated ASR 1002-SIP10-F and SPA for Cisco ASR 1002-F Router Description

Cisco ASR 1013 Specifications

General

Brand	Cisco
Model	ASR 1013
Category	Network Router
Language	English