Cisco ASR 1013 Hardware Installation Guide

g) Remove the small Phillips screw holding the eUSB board in-place (see the following figure).
Figure 256: Cisco ASR1000-RP eUSB Device
Cisco ASR 1000 Series RP eUSB device Phillips screw1
h) Gently pull the eUSB device up from its connector and remove it.
i) Place the eUSB device in an antistatic bag for return.
What to Do Next
You have removed the Cisco ASR1000-RP and eUSB component.
Remove and Replace the eUSB Device on the Cisco ASR 1006 and Cisco ASR
1004 Routers
To replace the eUSB component, follow these steps:
Cisco ASR 1000 Series Router Hardware Installation Guide
521
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Remove and Replace the eUSB Device on the Cisco ASR 1006 and Cisco ASR 1004 Routers

Cisco ASR 1013 Specifications

General

Brand	Cisco
Model	ASR 1013
Category	Network Router
Language	English