Appendix C Configuring the Switch with the CLI-Based Setup Program
Stacking the Switches (Optional)
C-6
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Step 1 Insert one end of the StackWise cable into the StackWise port at the back of a
switch. See Figure C-3.
Note Always use a Cisco-approved StackWise cable to connect the switches.
Step 2 Use the window in the StackWise cable to align the connector correctly. Secure
the screws tightly.
Step 3 Insert the other end of the cable into the connector of the other switch, and secure
the screws tightly.
See the “Connecting StackWise Cable to StackWise Ports” section on page 3-38
for detailed installation procedures on how to connect the switches in a stack.
Figure C-3 Connecting the StackWise Cable to a StackWise Port
CONSOLE
STACK 1
STACK 2
90530
To Next Page
Loading...
