Cisco Catalyst 3750 Hardware Installation Guide

vii
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Contents
CHAPTER 3 Switch Installation 3-1
Preparing for Installation 3-2
Warnings 3-2
EMC Regulatory Statements 3-4
U.S.A. 3-4
Class A Notice for Taiwan and Other Traditional Chinese Markets 3-4
VCCI Class A Notice for Japan 3-5
Class A Notice for Korea 3-5
Class A Notice for Hungary 3-6
Installation Guidelines 3-7
Verifying Package Contents 3-9
Verifying Switch Operation 3-10
Connecting a PC or Terminal to the Console Port 3-10
Powering On the Switch and Running POST 3-12
Powering Off the Switch and Disconnecting the Console Port 3-13
Planning the Stack 3-14
Planning Considerations 3-14
Powering Considerations 3-15
Cabling Considerations 3-15
Recommended Cabling Configurations 3-17
Installing the Switch 3-19
Rack Mounting 3-19
Removing Screws from the Switch 3-20
Attaching Brackets to the Catalyst 3750G-24TS Switch 3-21
Attaching Brackets to the Catalyst 3750-24TS, 3750G-24T, 3750G-12S,
3750-24PS, 3750-48PS, 3750G-16TD, and 3750-48TS Switches
3-26
Mounting the Switch in a Rack 3-29
Attaching the Cable Guide 3-31

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing