Cisco Catalyst 3750 Hardware Installation Guide

Contents
viii
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Wall Mounting 3-33
Attaching the Brackets to the Switch for Wall-Mounting 3-33
Attaching the RPS Connector Cover 3-34
Mounting the Switch on a Wall 3-35
Table or Shelf Mounting 3-37
Connecting StackWise Cable to StackWise Ports 3-38
Installing and Removing SFP Modules 3-41
Installing SFP Modules into SFP Module Slots 3-42
Removing SFP Modules from SFP Module Slots 3-44
Installing and Removing XENPAK Modules 3-45
Installing a XENPAK Module 3-46
Removing a XENPAK Module 3-49
Connecting to the 10/100 and 10/100/1000 Ports 3-51
Connecting to an SFP Module 3-55
Connecting to a Fiber-Optic SFP Module 3-56
Connecting to 1000BASE-T SFP Modules 3-58
Connecting to a XENPAK Module 3-59
Where to Go Next 3-61
CHAPTER 4 Troubleshooting 4-1
Understanding POST Results 4-1
Clearing the Switch IP Address and Configuration 4-2
Diagnosing Problems 4-4
Replacing a Failed Stack Member 4-9

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing