Cisco Catalyst 3750 Hardware Installation Guide

ix
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Contents
APPENDIX A Technical Specifications A-1
APPENDIX B Connector and Cable Specifications B-1
Connector Specifications B-1
10/100 and 10/100 /1000 Ports B-2
SFP Module Ports B-3
XENPAK Module Ports B-4
Console Port B-4
Cable and Adapter Specifications B-5
Two Twisted-Pair Cable Pinouts B-5
Four Twisted-Pair Cable Pinouts for 10/100 Ports B-6
Four Twisted-Pair Cable Pinouts for 1000BASE-T Ports B-7
Crossover Cable and Adapter Pinouts B-8
Identifying a Crossover Cable B-8
Adapter Pinouts B-9
APPENDIX C Configuring the Switch with the CLI-Based Setup Program C-1
Accessing the CLI C-2
Accessing the CLI Through Express Setup C-2
Accessing the CLI Through the Console Port C-3
Taking Out What You Need C-4
Stacking the Switches (Optional) C-5
Connecting to the Console Port C-7
Starting the Terminal Emulation Software C-9
Connecting to a Power Source C-9
Entering the Initial Configuration Information C-11
IP Settings C-11
Completing the Setup Program C-11

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing