Cisco Catalyst 4500 Series Message Guide

2-52
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSMODPORTMAN Messages
Error Message C4K_IOSMODPORTMAN-4-FANTRAYPARTIALFAILURE: A fan or thermistor/s in
system fan tray have failed
Explanation
This is a warning message indicating that one or more fans or thermal sensors in the
system fan tray have failed.
Recommended Action Schedule a time to replace the fan tray soon. System performance should not
be immediately affected.
Error Message C4K_IOSMODPORTMAN-4-FANTRAYREMOVED:Fan tray has been removed
Explanation
The fan tray was removed.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSMODPORTMAN-4-FANTRAYGOOD:Fan tray is okay
Explanation
The fan tray passed all tests and is operating normally.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSMODPORTMAN-4-INLINEPOWERSUPPLYBAD: Inline power from power
supply [dec] has failed or been turned off
Explanation
A PoE source from a power supply failed or was turned off. The hardware cannot make
a distinction between the two cases.
Recommended Action Verify that the incoming power is good, and if it is replace the power supply as
soon as possible.
Error Message C4K_IOSMODPORTMAN-4-NFLABSENT: Netflow Services Card absent or idprom
invalid on [char] supervisor.
Explanation
The recommended configuration for using the NetFlow Services Card is to have it
installed on both the standby and active supervisor engines. Otherwise, during switchover, the
system might lose its NetFlow capabilities.
Recommended Action Verify that the NetFlow Services Card is installed on both supervisor engines.
Error Message C4K_IOSMODPORTMAN-4-NFLIDPROMINVALID: Netflow Services Card has
invalid idprom on [char] supervisor
Explanation The IDPROM on the NetFlow Services Card on the supervisor engine indicated in the
message is invalid.
Recommended Action Contact your technical support representative.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E