EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
2-53
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSMODPORTMAN Messages
Error Message C4K_IOSMODPORTMAN-4-NFLMISMATCH: Netflow Services Cards have
mismatched [char]. ([dec] on [char] and [dec] on [char]).
Explanation
The IDPROM attributes of the NetFlow Services Cards installed on the active and the
standby supervisor engines do not match.
Recommended Action Verify that the NetFlow Services Card is correctly installed on both supervisor
engines.
Error Message C4K_IOSMODPORTMAN-4-PEMBAD: Power Entry Module has failed
Explanation
The external power supply source providing PoE power is bad.
Recommended Action Check the external power supply and replace it, if necessary. This message is
most likely to occur in a system using a 1400 W DC power supply and an external power shelf
providing DC current to the DC power supply.
Error Message C4K_IOSMODPORTMAN-4-POWERSUPPLYBAD:Power Supply [dec] has failed or
been turned off
Explanation
A power supply failed or was turned off. The hardware cannot make a distinction
between the two cases.
Recommended Action Replace the power supply as soon as possible.
Error Message C4K_IOSMODPORTMAN-4-POWERSUPPLYFANBAD:Fan of power supply [dec] has
failed
Explanation A power supply fan failed.
Recommended Action Replace the power supply as soon as possible.
Error Message C4K_IOSMODPORTMAN-4-POWERSUPPLYREMOVED:Power supply [dec] has been
removed
Explanation
The power supply was removed.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSMODPORTMAN-4-POWERSUPPLYOUTPUTDECREASED: Power supply [dec]
output has decreased
Explanation
The power supply output decreased. This could be due to switching it off, power failure,
or some failure in the power supply.
Recommended Action This is an informational message only. No action is required.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals