DescriptionTypeObject
Specifies the file system where the billing
record file should be written. This object
has a maximum length of 25 characters and
must specify a valid file system on the
router (such as slot0, disk1, or flash).
The Cisco CMTS writes the
billing records to this file system
using a file name that consists of
the router’s hostname followed by
a timestamp when the record was
written.
Note
DisplayStringccmtrCollectionFilesystem
(Optional) Indicates whether IP addresses
for customer premises equipment (CPE)
devices are omitted from the billing
records, so as to reduce the size of the
billing records and to improve
performance. The valid values are the
following:
• true—CPE information is present
(default).
• false—CPE information is omitted.
When set to true, a maximum of
5 CPE IP addresses for each cable
modem.
Note
TruthValueccmtrCollectionCpeList
(Optional) Indicates whether all
information for an individual cable modem
is combined into one record. Separate
counters are maintained for upstream and
downstream traffic, but those counters
include all service flows in that direction.
The valid values are as follows:
• true—All service flow information
for each cable modem is aggregated
into a single billing record. In this
configuration, the service flow ID
(SFID) for the billing record is set to
0 and the service class name (SCN)
is blank.
• false—Information for each cable
modem is not aggregated into a single
billing record, but instead each
service flow is recorded into its own
record (default).
TruthValueccmtrCollectionAggregate
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
138
Usage-Based Billing (SAMIS)
Enabling Usage-based Billing Feature File Mode Using SNMP Commands
To Next Page
Loading...
