Cisco IE 3000 - Page 7

Contents
vii
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Using the CLI to Manage Switch Clusters 6-14
Catalyst 1900 and Catalyst 2820 CLI Considerations 6-14
Using SNMP to Manage Switch Clusters 6-15
CHAPTER 7 Administering the Switch 7-1
Managing the System Time and Date 7-1
Understanding the System Clock 7-1
Understanding Network Time Protocol 7-2
Configuring NTP 7-3
Default NTP Configuration 7-4
Configuring NTP Authentication 7-4
Configuring NTP Associations 7-5
Configuring NTP Broadcast Service 7-6
Configuring NTP Access Restrictions 7-8
Configuring the Source IP Address for NTP Packets 7-10
Displaying the NTP Configuration 7-11
Configuring Time and Date Manually 7-11
Setting the System Clock 7-11
Displaying the Time and Date Configuration 7-12
Configuring the Time Zone 7-12
Configuring Summer Time (Daylight Saving Time) 7-13
Configuring a System Name and Prompt 7-14
Default System Name and Prompt Configuration 7-15
Configuring a System Name 7-15
Understanding DNS 7-15
Default DNS Configuration 7-16
Setting Up DNS 7-16
Displaying the DNS Configuration 7-17
Creating a Banner 7-17
Default Banner Configuration 7-17
Configuring a Message-of-the-Day Login Banner 7-18
Configuring a Login Banner 7-18
Managing the MAC Address Table 7-19
Building the Address Table 7-20
MAC Addresses and VLANs 7-20
Default MAC Address Table Configuration 7-20
Changing the Address Aging Time 7-21
Removing Dynamic Address Entries 7-21
Configuring MAC Address Notification Traps 7-21