Eth1/26 1 eth access down SFP not inserted 10G(D) --
Eth1/27 1 eth access down SFP not inserted 10G(D) --
Eth1/28 1 eth access down SFP not inserted 10G(D) --
Eth1/29 1 eth access down Link not connected 10G(D) --
Eth1/30 1 eth access down SFP not inserted 10G(D) --
Eth1/31 1 eth access down SFP not inserted 10G(D) --
Eth1/32 1 eth access up none 10G(D) --
--------------------------------------------------------------------------------
Port-channel VLAN Type Mode Status Reason Speed Protocol
Interface
--------------------------------------------------------------------------------
Po100 1 eth trunk up none a-10G(D) none
--------------------------------------------------------------------------------
Port VRF Status IP Address Speed MTU
--------------------------------------------------------------------------------
mgmt0 -- up 172.29.231.33 1000 1500
-------------------------------------------------------------------------------
Interface Secondary VLAN(Type) Status Reason
-------------------------------------------------------------------------------
Vlan1 -- up --
Vlan100 -- up --
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth100/1/1 1 eth access up none 10G(D) --
Eth100/1/2 1 eth access down Link not connected auto(D) --
Eth100/1/3 1 eth access up none 10G(D) --
Eth100/1/4 1 eth access down Link not connected auto(D) --
Eth100/1/5 1 eth access down Link not connected auto(D) --
Eth100/1/6 1 eth access down Link not connected auto(D) --
Eth100/1/7 1 eth access down Link not connected auto(D) --
Eth100/1/8 1 eth access down Link not connected auto(D) --
Eth100/1/9 1 eth access down Link not connected auto(D) --
Eth100/1/10 1 eth access up none 10G(D) --
Eth100/1/11 1 eth access down Link not connected auto(D) --
Eth100/1/12 1 eth access down Link not connected auto(D) --
Eth100/1/13 1 eth access down Link not connected auto(D) --
Eth100/1/14 1 eth access down Link not connected auto(D) --
Eth100/1/15 1 eth access up none 10G(D) --
Eth100/1/16 1 eth access down Link not connected auto(D) --
--------------------------------------------------------------------------------
Interface Status Description
--------------------------------------------------------------------------------
Lo10 up --
switch#
Note the following in the above display:
•
Ethernet 1/5 is a Layer 3-ready interface. The following fields in the display help identify an interface
as a configured Layer 3 interface:
◦ Mode—routed
◦ Status—up
◦ Reason—none
•
Ethernet 1/5.2 is a Layer 3 subinterface; however, the interface is not ready for Layer 3 configuration
(Status—down).
•
Interface Lo10 is a Layer 3 loopback interface.
This example shows how to display a brief summary of interfaces configured as FabricPath interfaces on a
switch that runs Cisco NX-OS Release 5.1(3)N1(1):
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Cisco Nexus 5000 Series Interfaces Command Reference
109
Show Commands
show interface brief
To Next Page
Loading...
