Cisco Nexus 5000 Series - Page 127

--------------------------------------------------------------------------------
Eth1/1 11576758 0 28326 106
switch#
This example shows how to display the information for an interface configured for Adapter-FEX:
switch# show interface ethernet 1/2
Ethernet1/2 is up
Hardware: 1000/10000 Ethernet, address: 000d.ecb0.fc49 (bia 000d.ecb0.fc49)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is vntag
full-duplex, 1000 Mb/s, media type is 10G
Beacon is turned off
Input flow-control is off, output flow-control is on
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
Last link flapped 00:00:13
Last clearing of "show interface" counters 1d05h
30 seconds input rate 0 bits/sec, 0 bytes/sec, 0 packets/sec
30 seconds output rate 1328 bits/sec, 166 bytes/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 0 bps, 0 pps; output rate 160 bps, 0 pps
RX
32453811602 unicast packets 649076 multicast packets 0 broadcast packets
32454460682 input packets 2206903326245 bytes
0 jumbo packets 0 storm suppression packets
3 runts 0 giants 1 CRC 0 no buffer
4 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
33695526841 unicast packets 36871810887 multicast packets 72059438 broadca
st packets
70639397169 output packets 4803378946692 bytes
0 jumbo packets
3 output errors 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble
0 Tx pause
2 interface resets
switch#
The above display shows the port mode configured as a virtual network tag (VNTag) port.
This example shows how to display the detailed configuration information of a specified subinterface:
switch# show interface ethernet 1/5.2
Ethernet1/5.2 is up
Hardware: 1000/10000 Ethernet, address: 0005.73a6.1dbc (bia 0005.73a6.1d6c)
Description: Eth 1/5.2 subinterfaces
Internet Address is 192.0.0.3/24
MTU 1500 bytes, BW 1500 Kbit, DLY 2000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 100
EtherType is 0x8100
switch#
This example shows how to display the brief configuration information of a specified subinterface:
switch# show interface ethernet 1/5.2 brief
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth1/5.2 100 eth routed up none 10G(D) --
switch#
Cisco Nexus 5000 Series Interfaces Command Reference
117
Show Commands
show interface ethernet