Send feedback to nx5000-docfeedback@cisco.com
1-9
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring SNMP
Configuring SNMP
Table 1-2 lists the CLI commands that enable the notifications for Cisco Nexus 5000 Series MIBs.
Note The snmp-server enable traps CLI command enables both traps and informs, depending on the
configured notification host receivers.
Note The license notifications are enabled by default. All other notifications are disabled by default.
Table 1-2 Enabling SNMP Notifications
MIB Related Commands
All notifications snmp-server enable traps
CISCO-AAA-SERVER-MIB snmp-server enable traps aaa
ENITY-MIB,
CISCO-ENTITY-FRU-CONTROL-MIB,
CISCO-ENTITY-SENSOR-MIB
snmp-server enable traps entity
snmp-server enable traps entity fru
CISCO-LICENSE-MGR-MIB snmp-server enable traps license
IF-MIB snmp-server enable traps link
CISCO-PSM-MIB snmp-server enable traps port-security
SNMPv2-MIB snmp-server enable traps snmp
snmp-server enable traps snmp authentication
CISCO-FCC-MIB snmp-server enable traps fcc
CISCO-DM-MIB snmp-server enable traps fcdomain
CISCO-NS-MIB snmp-server enable traps fcns
CISCO-FCS-MIB snmp-server enable traps fcs discovery-complete
snmp-server enable traps fcs request-reject
CISCO-FDMI-MIB snmp-server enable traps fdmi
CISCO-FSPF-MIB snmp-server enable traps fspf
CISCO-PSM-MIB snmp-server enable traps port-security
CISCO-RSCN-MIB snmp-server enable traps rscn
snmp-server enable traps rscn els
snmp-server enable traps rscn ils
CISCO-ZS-MIB snmp-server enable traps zone
snmp-server enable traps zone
default-zone-behavior-change
snmp-server enable traps zone merge-failure
snmp-server enable traps zone merge-success
snmp-server enable traps zone request-reject
snmp-server enable traps zone unsupp-mem
To Next Page
Loading...
