Cisco Nexus 5000 Series - Page 487

Send feedback to nx5000-docfeedback@cisco.com
1-17
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring SAN Port Channels
Default Settings
Used : 77 - 79
Unused: 1 - 76 , 80 - 256
Autocreated SAN port channels are indicated explicitly to help differentiate them from the manually
created SAN port channels. The following example shows how to display an autocreated port channel:
switch# show interface fc2/1
fc2/1 is trunking
Hardware is Fibre Channel, FCOT is short wave laser
Port WWN is 20:0a:00:0b:5f:3b:fe:80
...
Receive data field Size is 2112
Beacon is turned off
Port-channel auto creation is enabled
Belongs to port-channel 123
...
Default Settings
Table 1-3 lists the default settings for SAN port channels.
Table 1-3 Default SAN Port Channel Parameters
Parameters Default
Port channels FSPF is enabled by default.
Create port channel Administratively up.
Default port channel mode On.
Autocreation Disabled.