Cisco Nexus 5000 Series - Page 658

Send feedback to nx5000-docfeedback@cisco.com
1-16
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Troubleshooting
Default Settings
• show system internal rib unicast
• show system internal rib vsan-attributes
• show system internal fcfwd fwidxmap if_index
• show system internal fcfwd idxmap interface-to-port
• show system internal fcfwd pcmap
• show platform afm info global
• show platform afm info attachment brief
• show platform afm info group-cfg all
• show platform afm info lop all
• show platform software altos detail
• show platform software altos event-history errors
• show platform software altos event-history msgs
• show platform software altos ports all
• show platform hardware altos counters all
• show platform hardware altos counters interrupts all
• show platform hardware altos interrupts all detail
Default Settings
Table 1-1 lists the default settings for the features included in this chapter.
Table 1-1 Default Settings for Troubleshooting Features
Parameters Default
Timeout period to invoke fctrace 5 seconds
Number of frame sent by the fcping feature 5 frames
Remote capture connection protocol TCP
Remote capture connection mode Passive
Local capture frame limits 10 frames
FC ID allocation mode Auto mode