Cisco Nexus 7000 Series - Ospfv3 Example Configuration; Related Topics; Default Settings

Send document comments to nexus7k-docfeedback@cisco.com.
7-41
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 7 Configuring OSPFv3
OSPFv3 Example Configuration
OSPFv3 Example Configuration
The following example shows how to configure OSPFv3:
feature ospfv3
router ospfv3 201
router-id 290.0.2.1
interface ethernet 1/2
ipv6 address 2001:0DB8::1/48
ipv6 ospfv3 201 area 0.0.0.10
Related Topics
The following topics can give more information on OSPF:
• Chapter 6, “Configuring OSPFv2”
• Chapter 16, “Configuring Route Policy Manager”
Default Settings
Table 7-2 lists the default settings for OSPFv3 parameters.
Command Purpose
show ipv6 ospfv3 memory Displays the OSPFv3 memory usage statistics.
show ipv6 ospfv3 policy statistics area
area-id filter-list {in | out} [vrf {vrf-name
| all | default | management}]
Displays the OSPFv3 route policy statistics for an area.
show ipv6 ospfv3 policy statistics
redistribute {bgp id| direct | isis id | rip id
| static} vrf {vrf-name | all | default |
management}]
Displays the OSPFv3 route policy statistics.
show ipv6 ospfv3 statistics [vrf {vrf-name
| all | default | management}]
Displays the OSPFv3 event counters.
show ipv6 ospfv3 traffic [interface-type
number] [vrf {vrf-name | all | default |
management}]
Displays the OSPFv3 packet counters.
Table 7-2 Default OSPFv3 Parameters
Parameters Default
Hello interval 10 seconds
Dead interval 40 seconds
Graceful restart grace period 60 seconds