Cisco Nexus 7000 Series - Displaying BGP Statistics; Related Topics; Default Settings

Send document comments to nexus7k-docfeedback@cisco.com.
11-44
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 11 Configuring Advanced BGP
Displaying BGP Statistics
Displaying BGP Statistics
To display BGP statistics, use the following commands:
Related Topics
The following topics can give more information on BGP:
• Chapter 10, “Configuring Basic BGP”
• Chapter 16, “Configuring Route Policy Manager”
Default Settings
Table 11-1 lists the default settings for BGP parameters.
show {ip | ipv6} bgp options Displays the BGP status and configuration
information. This command has multiple options.
See the Cisco Nexus 7000 Series NX-OS Unicast
Routing Command Referencefor more
information.
show {ip | ipv6} mbgp options Displays the BGP status and configuration
information. This command has multiple options.
See the Cisco Nexus 7000 Series NX-OS Unicast
Routing Command Referencefor more
information.
show running-configuration bgp Displays the current running BGP configuration.
Command Purpose
Command Purpose
show bgp {ip | ipv6} {unicast | multicast}
[ip-address | ipv6-prefix] flap-statistics
[vrf vrf-name]
Displays the BGP route flap statistics. Use the clear bgp
flap-statistics command to clear these statistics.
show bgp sessions [vrf vrf-name] Displays the BGP sessions for all peers. Use the clear
bgp sessions command to clear these statistics.
show bgp sessions [vrf vrf-name] Displays the BGP sessions for all peers. Use the clear
bgp sessions command to clear these statistics.
show bgp statistics Displays the BGP statistics.
Table 11-1 Default BGP Parameters
Parameters Default
BGP feature disabled