Send document comments to nexus7k-docfeedback@cisco.com.
15-14
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 15 Managing the Unicast RIB and FIB
Additional References
Additional References
For additional information related to managing unicast RIB and FIB, see the following sections:
• Related Documents, page 15-14
• Feature History for Unicast RIB and FIB, page 15-14
Related Documents
Feature History for Unicast RIB and FIB
Table 15-1 lists the release history for this feature.
show hardware forwarding
dynamic-allocation status
Displays information about the TCAM allocation.
show {ip | ipv6} adjacency Displays the adjacency table.
show {ip | ipv6} route Displays IPv4 or IPv6 routes from the unicast RIB.
show routing Displays routes from the unicast RIB.
Command Purpose
Related Topic Document Title
Unicast RIB and FIB CLI commands Cisco Nexus 7000 Series NX-OS Unicast Routing Command
Reference
Table 15-1 Feature History for Unicast RIB and FIB
Feature Name Releases Feature Information
IPv6 forwarding inconsistency checker 4.2(1) Added support to check for inconsistencies in the IPv6
forwarding table.
Dynamic TCAM allocation 4.2(1) Added support for dynamically allocating TCAM blocks in
the FIB.
Per-packet load sharing 4.1(2) Added support to load balance per packet on an interface.
Unicast RIB and FIB 4.0(3) Added support to clear individual routes in unicast RIB and
FIB.
Unicast RIB and FIB 4.0(1) This feature was introduced.