Send document comments to nexus7k-docfeedback@cisco.com.
21-14
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 21 Configuring Object Tracking
Verifying Object Tracking Configuration
Verifying Object Tracking Configuration
To verify object tracking configuration information, use the following commands:
Object Tracking Example Configuration
This example shows how to configure object tracking for route reachability and use VRF Red to look up
reachability information for this route:
switch# config t
switch(config)# track 2 ip route 209.165.201.0/8 reachability
switch(config-track)# vrf member Red
switch(config-track)# copy running-config startup-config
Related Topics
See the following topics for information related to object tracking:
• Chapter 14, “Configuring Layer 3 Virtualization”
• Chapter 18, “Configuring GLBP”
• Chapter 19, “Configuring HSRP”
Default Settings
Table 21-1 lists the default settings for object tracking parameters.
Additional References
For additional information related to implementing object tracking, see the following sections:
• Related Documents, page 21-15
Command Purpose
show track [object-id] [brief] Displays the object tracking information for one
or more objects.
show track [object-id] interface [brief] Displays the interface-based object tracking
information.
show track [object-id] {ip | ipv6} route [brief] Displays the IPv4 or IPv6 route-based object
tracking information.
Table 21-1 Default Object Tracking Parameters
Parameters Default
Tracked Object VRF Member of default VRF
To Next Page
Loading...
