Cisco Nexus 7000 Series - Ipv4 Example Configuration; Verifying the Ipv4 Configuration; Default Settings; Additional References

Send document comments to nexus7k-docfeedback@cisco.com.
2-15
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 2 Configuring IPv4
Verifying the IPv4 Configuration
Verifying the IPv4 Configuration
To verify configuration information, use the following commands:
IPv4 Example Configuration
This example shows how to configure an IPv4 address:
config t
interface e 1/2
no switchport
ip address 192.2.1.1/16
Default Settings
Table 2-1 lists the default settings for IP parameters.
Additional References
For additional information related to implementing IP, see the following sections:
• Related Documents, page 2-16
• Standards, page 2-16
Command Purpose
show hardware forwarding ip verify Displays the IP packet verification configuration.
show ip adjacency Displays the adjacency table.
show ip arp Displays the ARP table.
show ip interface Displays IP related interface information.
show ip arp statistics [vrf vrf-name] Displays the ARP statistics.
Table 2-1 Default IP Parameters
Parameters Default
proxy ARP disabled