Cisco Nexus 7000 Series - Additional References; Default Settings; Ipv6 Example Configuration; Verifying the Ipv6 Configuration

Send document comments to nexus7k-docfeedback@cisco.com.
3-24
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 3 Configuring IPv6
Verifying the IPv6 Configuration
Verifying the IPv6 Configuration
To verify configuration information, use the following commands:
IPv6 Example Configuration
This example shows how to configure IPv6:
config t
interface ethernet 3/1
ipv6 address dc3:dc3::/64 eui64
ipv6 nd reachable-time 10
Default Settings
Table 3-5 lists the default settings for IPv6 parameters.
Additional References
For additional information related to implementing IPv6, see the following sections:
• Related Documents, page 3-25
• Standards, page 3-25
Command Purpose
show hardware forwarding ip verify Displays the IPv4 and IPv6 packet verification
configuration.
show ipv6 interface Displays IPv6 related interface information.
show ipv6 adjacency Displays the adjacency table.
show ipv6 icmp Displays ICMPv6 information.
show ipv6 nd Displays IPv6 neighbor discovery interface information.
show ipv6 neighbor Displays IPv6 neighbor entry.
Table 3-5 Default IPv6 Parameters
Parameters Default
ND reachable time 0 milliseconds
neighbor solicitation retransmit interval 1000 milliseconds