Send document comments to nexus7k-docfeedback@cisco.com.
20-12
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 20 Configuring VRRP
Configuring VRRP
Ensure that the authentication configuration is identical for all VRRP devices in the network.
Ensure that you have enabled the VRRP feature (see the “Configuring VRRP” section on page 20-7).
Ensure that you have configured an IP address on the interface (see the “Configuring IPv4 Addressing”
section on page 2-7.
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1. config t
2. interface interface-type slot/port
3. vrrp number
4. shutdown
5. authentication text password
6. no shutdown
7. show vrrp
8. copy running-config startup-config
To Next Page
Loading...
