Send document comments to nexus7k-docfeedback@cisco.com.
20-18
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 20 Configuring VRRP
Configuring VRRP
Note VRRP does not support Layer 2 interface tracking.
BEFORE YOU BEGIN
Ensure that you have enabled the VRRP feature (see the “Configuring VRRP” section on page 20-7).
Ensure that you have configured an IP address on the interface (see the “Configuring IPv4 Addressing”
section on page 2-7.
Ensure that you have enabled the virtual router (see the “Configuring VRRP Groups” section on
page 20-8).
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1. config t
2. interface interface-type slot/port
3. vrrp number
4. shutdown
5. track interface type number priority value
6. no shutdown
7. show vrrp
8. copy running-config startup-config
To Next Page
Loading...
