Cisco NSS32 User Manual

Managing the System
Disk Management
Cisco Small Business NSS300 Series Smart Storage Administration Guide 120
3
To run the iSCSI Quick Configuration Wizard and configure the iSCSI target
service on the NAS:
STEP 1 Choose Disk Management > iSCSI from the Navigation menu. The Portal
Management window opens.
STEP 2 Click Enable iSCSI Target Service and enter an iSCSI Service Port number. The
default service port is 3260.
STEP 3 Optionally, click Enable iSNS to enable Internet Storage Name Service (iSNS) and
enter the iSNS Server IP address.
STEP 4 Click Apply to save the settings.
STEP 5 Click the Target Management tab to create iSCSI targets on the NAS. If you have
not created any iSCSI targets, the Quick Configuration Wizard appears.
STEP 6 Click OK to launch the wizard.
STEP 7 From the iSCSI Quick Configuration Wizard window options, click iSCSI Target
with a mapped LUN, then click Next.
STEP 8 Click Next again and the wizard will guide you through:
• Creating an iSCSI target
• Creating an iSCSI LUN and mapping it to the target
STEP 9 From the Create New iSCSI Target window, enter the following parameters:

Cisco NSS32 Specifications

General

Brand	Cisco
Model	NSS32
Category	Storage
Language	English