• PID VID — Version number of the hardware.
Firmware Information
• Firmware Version — Version number of the installed firmware.
• Firmware MD5 Checksum — A value used for file validation.
Port Status
• Port ID — Defined name and number of the port.
• Interface — Name of the port used for the connection.
• Enabled — Status of the port.
• Speed — The speed (in Mbps) of the device after auto negotiation.
IPv4 and IPv6
• Interface — Name of the interface.
• IP Address — IP address assigned to the interface.
• Default Gateway — Default gateway for the interface.
• DNS — IP address of the DNS server.
• Dynamic DNS — IP address of the DDNS for the interface: Disabled or Enabled.
• Renew — Click to renew the IP address.
• Release — Click to release the interface.
VPN Status
• Type — Type of the VPN tunnel.
• Active — Is Enabled or Disabled.
• Configured — VPN tunnel’s status whether it is configured or not.
• Max Supported Sessions — The maximum number of tunnels supported on the device.
• Connected Session — Status of the tunnel.
Firewall Setting Status
• Stateful Packet Inspection (SPI) — also known as dynamic packet filtering, monitors the state of active
connections and uses this information to determine which network packets are allowed through the
firewall.
• Denial of Service (Dos) — Status of the Dos filter service is enabled (On) or disabled (Off). A DoS
attack is an attempt to make a machine or network resource unavailable to its intended users.
RV345/345P Administration Guide
6
Status and Statistics
System Summary
To Next Page
Need help?
General
