SMTP mail account configuration such as email addresses, password, message digest; optional parameters,
SMTP server port number, SSL, TLS.
Step 1
In the Email Server section, check Email Syslogs to enable the router to send email alerts when events are logged.
Step 2
In the Email Settings section, click Link to Email Setting page to configure your email settings.
Step 3
In the Email Subject section, enter the subject.
Step 4
In the Severity section, select the severity level from the drop-down list.
Step 5
In the Log Queue Length section, enter a range from 1 to 1000. The default is 50.
Step 6
In the Log Time Threshold section, select the time threshold from the drop-down list.
Step 7
In the Real Time Email Alerts section, check All or any of the e-mail alerts categories that you want logged on the
device.
Remote Syslog Server
A remote syslog server allows you to separate the software that generates the messages and events from the
system that stores and analyzes them. When enabled, the network driver sends messages to a syslog server
on the local Intranet or Internet through a VPN tunnel. The syslog server can be configured by specifying the
name or IP address.
Step 1
In the Syslog Server section, check Enable to enable sending system logs to a remote server.
Step 2
In the Syslog Server1 field, enter the IP address of a syslog server to which the log messages should be sent.
Step 3
In the Syslog Server2 field, enter the IP address of a syslog server to which the log messages should be sent.
Step 4
Click Apply.
Email
You can configure your device’s email server to your specifications.
Configuring Email
To configure the email server, follow these steps.
Step 1
Select System Configuration > Email.
Step 2
Under Email Server, enter the following:
Enter the address of the SMTP server.SMTP Server
Enter the SMTP port.SMTP Port
RV345/345P Administration Guide
28
System Configuration
Remote Syslog Server
To Next Page
Loading...
Need help?
General
