Cisco RV345 Administration Guide

Initial Setup Wizard
You can check the connection and configure the basic router settings on the Initial Setup Wizard page. From
the Run Setup Wizard page, you can follow the instructions that guide you through the process for configuring
the device.
Step 1
Click System Configuration > Initial Setup Wizard.
Step 2
Click Next to go to Check Connection page. If your router has detected a connection, the connection details are displayed
on this page.
Step 3
Select Interface from the drop-down list.
Step 4
Click Next.
Step 5
Under Configure Router Select Connection Type, select your internet connection type.
Step 6
If you select Dynamic IP or DHCP, click Next.
Step 7
If you select Static IP Address, click Next and configure the settings below.
Enter the static IP address.Static IP Address
Enter the subnet mask.Subnet Mask
Enter the gateway IP.Gateway IP
Enter the IP address of the DNS.DNS
Step 8
If you select PPPoE, click Next and configure the settings below.
Enter the account name.Account Name
Enter the password.Password
Confirm the password.Confirm Password
Step 9
If you select PPTP or L2TP, click Next and configure the settings below.
Enter the account name.Account Name
Enter the password.Password
Confirm the password.Confirm Password
Enter the static IP address.Static IP Address
Enter the subnet mask.Subnet Mask
Enter the gateway IP.Gateway IP
Enter the remote server.Remote Server
Enter the IP address of the DNS.DNS
RV345/345P Administration Guide
24
System Configuration
Initial Setup Wizard

Cisco RV345 Specifications

General

WAN Ports	2
LAN Ports	16
Max VPN Tunnels	50
Firewall Throughput	900 Mbps
RAM	512 MB
Flash Memory	256 MB
Gigabit Ethernet Ports	18
Firewall Protection	Yes
VPN Support	Yes
Wireless	No
Device Type	Router
Encryption	AES, 3DES
Operating Temperature	0 to 40 °C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Humidity	10% to 85% noncondensing
USB Ports	2
Ports	18 x RJ-45