Cisco RV345 Administration Guide

Step 8
Click Apply.
Teleworker VPN Client
The Teleworker VPN Client feature minimizes the configuration requirements at remote locations by allowing
the device to work as a Cisco VPN hardware client. When the Teleworker VPN Client starts the VPN
connection, the IPSec VPN server pushes the IPSec policies to the Teleworker VPN Client and creates the
corresponding tunnel.
To configure the Teleworker VPN Client, follow these steps:
Step 1
Click VPN > Teleworker VPN Client and configure the following:
Check On or Off.Only one Teleworker VPN Client can have an active connection at
startup.If you enable one Teleworker VPN Client on startup, it will disable this option
on other client rules.
Teleworker VPN Client
Check On or Off.Auto Initiation Retry
Enter the time in seconds (Range 120 to 1800).Retry Interval
Enter the maximum number of retries (Range 0 to 16).Retry Limit
Step 2
Click Apply.
Step 3
In the Teleworkers VPN Client table, click Add.
Step 4
Provide the following information in the Basic Settings section:
Enter a name for the profile.Name
Enter the remote server's IP address.Server (Remote Address)
To start connection on startup. At any point, only one profile can be in On state to start
negotiations at startup
Active Connection on
Startup
RV345/345P Administration Guide
89
VPN
Teleworker VPN Client

Cisco RV345 Specifications

General

Brand	Cisco
Model	RV345
Category	Network Router
Language	English