To configure the VLAN settings, enter the following information:
Step 1
Select LAN > VLAN Settings.
Step 2
In the VLAN Table, click Add.
Step 3
Enter the VLAN ID. (Range is 1-4093).
Step 4
Check to enable the Inter-VLAN.
Step 5
Enter the IPv4 address.
Step 6
Enter the Prefix, Prefix Length, and Interface Identifier.
Step 7
Click Edit or Delete to edit or delete the VLAN table configurations.
Step 8
In the VLANs to Port Table, click Edit to assign a VLAN to a LAN port. Specify the following information for each of
the VLAN listed in the table.
• Untagged — Select Untagged from the drop-down list to untag the port.
• Tagged — Select Tagged from the drop-down list, to include the port as a member for the selected VLAN. Packets
sent from this port destined to the chosen VLAN will have the packets tagged with the VLAN ID. If there are no
untagged VLANs on a port, the interface automatically joins the VLAN1.
• Excluded — Select Excluded from the drop-down list, to exclude the port from the selected VLAN. When the
untagged VLANs are excluded from a port, the port automatically joins the default VLAN.
Step 9
Click Apply.
LAN/DHCP Settings
DHCP setup configures the DHCP server for relay or Option 82 (DHCP relay agent information option) for
LAN clients to obtain IP addresses. DHCP server maintains local pools and leases. It also allows LAN clients
to connect to a remote server for obtaining IP address.
Option 82 enables a DHCP relay agent to include information about itself when forwarding client-originated
DHCP packets to a DHCP server. The DHCP server can use this information to implement IP addressing or
other parameter-assignment policies.
To configure the LAN/DHCP settings, follow these steps:
Step 1
Select LAN > LAN/DHCP Settings.
Step 2
In the LAN/DHCP Settings Table click Add.
Step 3
If you choose Interface, select a VLAN from the drop-down list and click Next.
Step 4
To configure the DHCP for IPv4, select the DHCP type for IPv4.
Disables the DHCP server for IPv4 on this device. There are no additional parameters
to complete.
Disabled
The DHCP server assigns addresses to clients from their respective pools.Server
RV345/345P Administration Guide
56
LAN
LAN/DHCP Settings
To Next Page
Loading...
Need help?
General
