195
Chapter 11: Configuring SNMP
Defining Trap Management
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
11
• User Name — Defines the user to whom SNMP notifications are sent.
• Security Level — (SNMP v3) Defines the means by which the packet is authenticated. The possible
field values are:
– No Authentication — Indicates the packet is neither authenticated nor encrypted.
– Authentication — Indicates the packet is authenticated.
– Privacy — Indicates the packet is both authenticated and encrypted.
The UDP Port Notification Recipient area contains the following fields:
• UDP Port — Displays the UDP port used to send notifications. The default is 162.
• Filter Name — Indicates if the SNMP filter for which the SNMP Notification filter is defined.
• Timeout — Indicates the amount of time (seconds) the device waits before re-sending informs. The
default is 15 seconds.
• Retries — Indicates the amount of times the device re-sends an inform request. The default is 3
seconds.
3. Define the relevant fields.
4. Click Apply. The SNMP Notification Receivers are defined, and the device is configured.
To Next Page
Loading...
Need help?
General
