Getting Started
Starting the Web-Based Configuration Utility
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 8
1
address>) to the local intranet zone. The IP address can also be specified
as the subnet IP address, so that all addresses in the subnet are added to
the local intranet zone.
• If you have multiple IPv6 interfaces on your management station, use the
IPv6 global address instead of the IPv6 local address to access the WAP
device from your browser.
Launching the Web-Based Configuration Utility
To open the configuration utility:
STEP 1 Open a web browser.
Enter the IP address of the WAP device that you are configuring in the address bar
on the browser and then press Enter. The Login page opens.
• To find your IP address, you can use the Cisco FindIT Network Discovery
Utility. This tool enables you to automatically discover all supported Cisco
Small Business devices in the same local network segment as your
computer. For more information, go to cisco.com and enter www.cisco.com/
go/findit.
• For further instructions on how to locate the IP address of your WAP device,
see the WAP device Quick Start Guide.
STEP 2 Enter the user name and password. The factory default user name is cisco and the
default password is cisco.
STEP 3 Click Log In. The Access Point Setup Wizard page opens.
If this is the first time that you logged on with the default user name (cisco) and the
default password (cisco) or your password has expired, the Change Admin
Password page opens. Enter the new password and confirm it, click Apply, and
then click Close. The new password is saved. Then, enter the user name cisco and
the new password on the Login page.
See Using the Access Point Setup Wizard for instructions on using the wizard.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
