Single Point Setup
Access Points
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 162
10
Access Points
The Access Points page allows you to enable or disable Single Point Setup on a
WAP device, view the cluster members, and configure the location and cluster
name for a member. You can also click the IP address of a member to configure
and view data on that device.
Configuring the WAP Device for Single Point Setup
To configure the location and name of an individual Single Point Setup cluster
member:
Transmit Power
Radio Configuration Settings and Parameters that are Not Propagated in
Single Point Setup
Other Configuration Settings and Parameters That Are Not Propagated in
Single Point Setup
Bandwidth Utilization Port Settings
Bonjour VLAN and IPv4
IPv6 Address WDS Bridge
IPv6 Tunnel WPS
Packet Capture WorkGroup Bridge
To Next Page
Loading...
