Cisco WAP321 - Viewing Details for a Cluster Member

Single Point Setup
Wireless Neighborhood
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 173
10
Viewing Details for a Cluster Member
To view details on a cluster member, click the IP address of a member at the top of
the page.
The following details for the device appear below the Neighbors list.
• SSID—The Service Set Identifier for the neighboring access point.
• MAC Address—The MAC address of the neighboring access point.
• Channel—The channel on which the access point is currently broadcasting.
• Rate—The rate in megabits per second at which this access point is
currently transmitting. The current rate is always one of the rates shown in
Supported Rates.
• Signal—The strength of the radio signal detected from the access point,
measured in decibels (dB).
• Beacon Interval—The beacon interval used by the access point.
• Beacon Age—The date and time of the last beacon received from this
access point.