Wireless
WPS Process
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 107
5
Instance Status
The Instance Status area shows the following information about the selected WPS
instance:
• WPS Operational Status—Whether or not the WPS instance is operational.
• AP Lockdown Status—Whether the AP is in lockdown mode, in which
external registrars are blocked from registering with the AP. When in
lockdown status, this field reports the start time of the lockdown, whether it
is temporary or permanent, and if temporary, the duration of the lockdown
period. When not in lockdown mode, the status appears as Disabled.
• Failed Attempts with Invalid PIN—The number of times an external
registrar has tried and failed to register with the WAP device.
When in lockdown status, the following fields appear:
• AP Lockdown Duration—The duration in minutes for which the WAP is
locked. When the WAP is permanently locked, this value is set to –1.
• AP Lockdown Timestamp—The time when the WAP device was locked.
You can click Refresh to update the page with the most recent status information.
WPS Process
You can use the WPS Process page to use WPA to enroll a client station on the
network. You can enroll a client using a pin or using the push button method, if
supported on the client station.
Enrolling a Client Using the PIN Method
To enroll a client station using the PIN method:
STEP 1 Obtain the PIN from the client device. The PIN may be printed on the hardware
itself, or may be obtained from the software interface of the device.
STEP 2 Select Wireless > WPS Process in the navigation pane.
STEP 3 Enter the PIN of the client in the PIN Enrollment text box and click Start.
STEP 4 Within two minutes, enter the WAP pin on the software interface of the client
device. The WAP pin is configured on the WPS Setup page.
To Next Page
Loading...
