6
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 110
System Security
This chapter describes how to configure security settings on the WAP device
device.
It contains these topics:
• RADIUS Server
• 802.1X Supplicant
• Password Complexity
• WPA-PSK Complexity
RADIUS Server
Several features require communication with a RADIUS authentication server. For
example, when you configure Virtual Access Points (VAPs) on the WAP device, you
can configure security methods that control wireless client access (see the Radio
page). The Dynamic WEP and WPA Enterprise security methods use an external
RADIUS server to authenticate clients. The MAC address filtering feature, where
client access is restricted to a list, may also be configured to use a RADIUS server
to control access. The Captive Portal feature also uses RADIUS to authenticate
clients.
You can use the Radius Server page to configure the RADIUS servers that are
used by these features. You can configure up to four globally available IPv4 or IPv6
RADIUS servers; however, you must select whether the RADIUS client operates in
IPv4 or IPv6 mode with respect to the global servers. One of the servers always
acts as a primary while the others act as backup servers.
NOTE In addition to using the global RADIUS servers, you can also configure each VAP to
use a specific set of RADIUS servers. See the Networks page.
To configure global RADIUS servers:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
