Cisco WAP321 - Viewing Instance Status Information; Viewing Instance Summary Information

Wireless
WPS Process
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 109
5
Viewing Instance Status Information
The Instance Status section shows the following information about the WPS
instance selected in the WPS Instance ID list:
• WPS Status—Whether the selected WPS instance is enabled or disabled.
• WPS Configuration State—Whether the VAP will be configured from the
external registrar as a part of the WPS process.
• Transaction Status—The status of the last WPS transaction. The possible
values are None, Success, WPS Message Error, and Timed Out.
• WPS Operational Status—The status of the current or most recent WPS
transaction. The possible values are Disabled, Ready, Configuring, Proxying,
and Adding Enrollee. When no WPS transactions have occurred since WPS
was enabled, Ready appears.
• AP Lockdown Status—Whether the instance is currently in lockdown state.
• Failed Attempts with Invalid PIN—The number of times an attempt at
authenticating an external registrar has failed due to an invalid password.
Viewing Instance Summary Information
This information appears for WPS instance:
• WPS Radio
• WPS VAP
• SSID
• Security
If the WPS Configuration State field on the WPS Setup page is set to
Unconfigured, then the SSID and Security values are configured by the external
registrar. If the field is set to Configured, then these values are configured by the
administrator.
NOTE You can click Refresh to update the page with the most recent status information.