Wireless
WorkGroup Bridge
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 95
5
NOTE There is an arrow next to SSID for SSID Scanning; this feature is
disabled by default, and is enabled only if AP Detection is enabled in Rogue
AP Detection (which is also disabled by default).
• Security—The type of security to use for authenticating as a client station
on the upstream WAP device. Choices are:
- None
- Static WEP
- WPA Personal
- WPA Enterprise
See Configuring Security Settings for information about WEP and WPA
Personal security settings.
• VLAN ID—The VLAN associated with the BSS.
NOTE The Infrastructure Client Interface will be associated with the
upstream WAP device with the configured credentials. The WAP device may
obtain its IP address from a DHCP server on the upstream link. Alternatively,
you can assign a static IP address. The Connection Status field indicates
whether the WAP is connected to the upstream WAP device. You can click
the Refresh button at the top of the page to view the latest connection
status.
STEP 4 Configure the following additional fields for the Access Point Interface:
• Status—Select Enable for the Access Point Interface.
• SSID—The SSID for the Access Point Interface does not need to be the
same as the Infrastructure Client SSID. However, if attempting to support a
roaming type of scenario, the SSID and security must be the same.
• SSID Broadcast—Select if you want the downstream SSID to be broadcast.
SSID Broadcast is enabled by default.
• Security—The type of security to use for authenticating. Choices are:
- None
- Static WEP
- WPA Personal
• MAC Filtering—Select one of these options:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
