3.3.3 E-QUE E1/T1 interface card
The E-QUE E1/T1 interface allows the Eclipse HX-Median to connect to
FreeSpeak/CellCom/ FreeSpeak II antennas, FreeSpeak/CellCom/ FreeSpeak II
antenna splitters, and E1 and T1 trunk lines.
Each E-QUE interface card set comprises:
A front card with a reset button and various status indicators.
A rear card with eleven RJ-45 ports giving eight standard Ethernet ports,
DECT sync in and out and a LAN port for diagnostic use.
Each E-QUE front card has status LEDs for power, port activity and LAN status.
The port activity LEDs show when:
A device is connected to an E1 port.
A connection has been established between the E1 port and the
connected device.
3.3.4 E-MADI64 interface card
The E-MADI64 is a MADI (Multichannel Audio Digital Interface) card, providing
up to 64 duplex channels of AES3 digital audio over a coaxial cable or fiber pair
between compatible devices.
The E-MADI64 card supports up to 32 V-Series Panels over a suitable
infrastructure. See 6 E-MADI64 card for more information
Note: You have the option in EHX to limit the E-MADI64 card to either 32, 56 or 64
channels of audio. All MADI channels have standard EHX settings, including VOX
and in-use tally. See also 6 E-MADI64 card.
Each E-MADI64 card set comprises:
A front card with pin reset and various status indicators (including
channel quantity, sample rate, power and diagnostic (active and error)
indicators).
A rear card with a MADI fiber connector, MADI input and output coaxial
cable connectors, and coaxial Video black and burst / Tri Level HD /
Word clock sync input.
3.3.5 IVC-32 IP interface card
The IVC-32 interface allows the Eclipse HX matrix to connect to IP enabled V-
Series panels and Concert users using an IP network.
Each IVC-32 interface comprises:
To Next Page
Loading...
