A front card with a reset button and various status indicators.
A rear card with eleven RJ-45 ports giving eight E1/T1 ports (not used),
DECT sync in and out (not used) and a LAN port for IP connectivity.
Each IVC-32 front card has status LEDs for power, port activity and LAN status.
The LAN indicators show whether there is a LAN connection and the IP activity
on the LAN port.
3.3.5.1 IVC-32 Redundant Card
You can add an IVC-32 Redundant Card that provides fail-over redundancy for
one or more IVC-32 Cards in the matrix.
An IVC-32 Card will fail-over to the IVC-32 Redundant Card under the following
conditions:
• All configured VoIP ports are unconnected for longer than 90 seconds.
• The IVC-32 Card is detected as absent from the VME backplane.
• It is requested via the EHX Event Log.
A switch back from a redundant card back to a failed card only occurs under the
following condition:
The redundant card has failed. If the original card is still in error, then it
will switch back and forward until corrective action is taken.
3.3.6 LMC-64 interface card
The LMC-64 interface allows the Eclipse HX-Median to provide Production
Maestro Pro (routing software) clients with audio level metering of partylines
(conferences) and four-wire ports over an IP network.
Each LMC-64 interface comprises:
A front card with a reset button and various status indicators.
A rear card with eleven RJ-45 ports giving eight E1/T1 ports (not used),
DECT sync in and out (not used) and a LAN port for IP connectivity.
Each LMC-64 front card has status LEDs for power, port activity and LAN status.
The LAN indicators show whether there is a LAN connection and the IP activity
on the LAN port.
3.3.7 E-DANTE64-HX interface card
This is a Clear-Com matrix interface card that is enabled to work with Dante
network protocols and software. Using the E-Dante64 card you can transport
many channels of high quality audio via a Clear-Com matrix to multiple Dante
To Next Page
Loading...
Need help?
General
