enabled devices using standard Ethernet network structure (up to 64 channels
per E-DANTE64 card).
You can configure each E-DANTE64-HX card with EHX configuration software to
support up to 16, 32 or 64 cards.
Note: Dante enabled devices also interface with AES67 devices.
Each E-DANTE64-HX card set consists of:
A front panel with a reset button and status LEDs
A rear panel with network connectors and status LEDs.
For more information, see 11 E-Dante64-HX card.
3.4 Interface modules
Interface modules convert the four-wire signals of a central matrix port to other
types of signals that communicate with devices such as telephones, camera
intercoms, two-way radios, and so on. In this way non-four-wire devices can
communicate with the central matrix.
Each interface module has hardware connectors to connect to both the central
matrix and the external device that communicates with the central matrix.
Most interface modules connect to the central matrix via shielded CAT5 cable
terminated with RJ-45 connectors.
Note: The type of cable used to connect the interface module to the non-four-wire
device varies with the device. For more information, see the dedicated user
guide / manual for that interface module.
The following interface modules are compatible with the Eclipse HX-Median
matrix:
TEL-14 telephone interface module.
CCI-22 dual party-line interface module.
FOR-22 four-wire interface.
GPI-6 general purpose inputs interface module.
RLY-6 relay (general-purpose outputs) interface module.
AES-6 digital interface module used with V-Series panels fitted with the
AES-3 option card. It may also be used with AES-3 compliant third party
equipment.
Note: Additional interface modules may be added to the Eclipse HX-Median, using
separate interface module frames such as the IMF-3 and IMF-102. For more
information, see the dedicated user guide / manual for that particular interface
frame.
Note: DIG-2 interface modules are not compatible with the HX-Median frame format.
To Next Page
Loading...
Need help?
General
